DID outgoing matching rule
Matching Outbound Dial Peers
The method a router uses to select an outbound dial peer depends on whether ISDN DID is configured in the inbound POTS dial peer. If DID is not configured in the inbound POTS dial peer, the router collects the incoming dialed string digit by digit. As soon as one dial peer is matched, the router immediately places the call using the configured attributes in the matching dial peer.
If DID is configured in the inbound POTS dial peer, the router uses the full incoming dial string to match the destination pattern in the outbound dial peer. With DID, the setup message contains all the digits necessary to route the call; no additional digit collection is required. If more than one dial peer matches the dial string, all of the matching dial peers are used to form a rotary group. The router attempts to place the outbound call leg using all of the dial peers in the rotary group until one is successful. From http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/
123 cgcr/vvfax_c/int_c/dpeer_c/dp_confg.htm#wp1067791
Just a test for comments
Comment by woojar — 2006-12-26 @ 1:48 pm